HOT PLATE WELDING MACHINE WITH DRILLING GS-001-D-HP-E
Hot plate welding machine supplied with drilling unit with electric movement. Hot plate welding and drilling of most of the thermoplastic materials, including the most problematic. Quick change and automatic recognition of the installed welding and drilling fixture. Possibility to carry out also other finishing and testing operations.
-
GS-001-D-HP-E
HOT PLATE WELDING MACHINE WITH DRILLING UNIT WITH ELECTRIC MOVEMENT
GENERAL CHARACTERISTICS
- 1 working station with single blocking die
- average equipping time: 15 minutes
- quick change of the blocking die, welding clamp, hot-plate and drilling tools
- marking by engraving of the good articles
- possibility to carry out other finishing operations
- simplified and guided programming in logic order
- module for remote assistance
- recommended for the welding of articles produced by means of injection moulding, extrusion moulding, compression moulding, thermoforming, blow moulding, suction 2d/3d (2k) and rotational moulding
HOT PLATE WELDING DEVICE
- automatic detection of the installed fixture
- automatic loading of all parameters
- possibility to store up to 255 welding recipes
- use of hot-plate with quick change sized and shaped according to the article and component to weld
- maximum temperature of the hot-plate: 400° (beyond: upon request)
- differential adjustment of the temperature on the article side and on the element side
- minimum time of closing for joining after the end of the warming: < 1,5 seconds
- automatic adaptation of the melting parameter of the article and of the joining parameter of the element, with elimination of the articles that do not comply with the coupling parameters and tolerances that have been set
- possibility to change coupling parameters and tolerance on the operator panel
- mechanical adjustment of the melting parameter of the element with possibility to carry out changes manually
- pneumatic adjustment of the different melting and joining parameters of the components with the possibility to adjust them on the operator panel
DRILLING DEVICE
- automatic detection of the installed device
- automatic loading of all parameters
- maximum drilling device: 50 mm
- drilling with fingernail-shaped tool and with helical-shaped tool
- the drilling with helical shaped tool is carried out when the mechanical and dimensional characteristics of the components do not allow the drilling with fingernail-shaped tool
- drilling with helical shaped tool: if necessary the articles must be cleaned from the chips and de-flashed manually
- drilling with fingernail-shaped tool: automatic extraction of the chip-disk and confirmation of the extraction by means of optic check
-
-