BIVALENT HOT PLATE/INFRARED WELDING MACHINE WITH DRILLING GS-001-D-HP+I-E

GS-001-HP+I-E

BIVALENT WELDING MACHINE, HOT PLATE WELDING AND LOCALIZED INFRARED WELDING, WITH DRILLING UNIT

GENERAL CHARACTERISTICS

• 1 working station with single blocking die
• average equipping time: 15 minutes
• automatic detection of the installed welding fixture
• automatic loading of all the welding parameters
• possibility to store up to 255 welding recipes
• marking by incision of the good articles
• simplified guided programming in logic order
• module for remote assistance
• recommended for the welding of articles produced by means of injection moulding, extrusion moulding, compression moulding, thermoforming, blow moulding, suction 2d/3d (2k) and rotational moulding
• optional: the blocking dies used during the hot-plate welding process can be used also during the localized infrared welding process, integrating the emitter

HOT PLATE WELDING DEVICE

• use of hot-plate with quick change sized and shaped according to the article and component to weld
• maximum dimensions of the hot-plates:300 mm x 200 mm
• differential adjustment of the temperature on the article side and on the element side
• maximum temperature of the hot-plate: 500°
• minimum switch time for the joining after the end of the warming: < 1,5 seconds
• automatic adaptation of the melting parameter of the article and of the joining parameter of the element, with elimination of the articles that do not comply with the coupling parameters and tolerances that have been set
• possibility to change coupling parameters and tolerance on the operator panel
• mechanical adjustment of the melting parameter of the element with possibility to carry out changes manually
• pneumatic adjustment of the different melting and joining parameters of the components with the possibility to adjust them on the operator panel

LOCALIZED INFRARED WELDING DEVICE

• maximum dimensions of the emitter: 300 mm x 200 mm
• maximum temperature of the emitter: 500°
• differential adjustment of the temperature on the article side and on the element side
• minimum switch time for the joining after the end of the warming: < 1 second
• automatic adaptation of the melting parameter of the article and of the joining parameter of the element, with elimination of the articles that do not comply with the coupling parameters and tolerances that have been set
• possibility to change coupling parameters and tolerance on the operator panel
• pneumatic adjustment of the different melting and joining parameters of the components with the possibility to adjust them on the operator panel

DRILLING DEVICE

• automatic detection of the installed device
• automatic loading of all parameters
• maximum drilling device: 50 mm
• drilling with fingernail-shaped tool and with helical-shaped tool
• the drilling with helical shaped tool is carried out when the mechanical and dimensional characteristics of the components do not allow the drilling with fingernail-shaped tool
• drilling with helical shaped tool: if necessary the articles must be cleaned from the chips and de-flashed manually
• drilling with fingernail-shaped tool: automatic extraction of the chip-disk and confirmation of the extraction by means of optic check