BIVALENT HOT PLATE/INFRARED WELDING MACHINE FOR WIDE SURFACES GS-040-HP+I-E, GS-O41-HP+I-E, GS-042-HP+I-E, GS-043-HP+I-E

GS-041-HP+I-E, GS-042-HP+I-E, GS-043-HP+I-E

BIVALENT WELDING MACHINE, HOT-PLATE WELDING AND LOCALIZED INFRARED WELDING, FOR WIDE SURFACES WITH ELECTRIC MOVEMENT

GENERAL CHARACTERISTICS

• 1 working station with single or multiple blocking die
• quick change of the welding fixture
• automatic detection of the installed welding fixture
• average equipping time: 15 minutes
• possibility to store up to 255 welding recipes
• simplified guided programming in logic order
• module for remote assistance
• welding of articles produced by means of injection moulding, extrusion moulding, compression moulding, thermoforming, blow moulding, suction 2d/3d (2k) and rotational moulding
• optional: the blocking dies used during the hot-plate welding process can be used also during the localized infrared welding process, integrating the emitter

MAXIMUM DIMENSIONS OF THE HOT-PLATE AND THE INFRARED EMITTER

• GS-040: 400 mm x 300 mm
• GS-041: 600 mm x 400 mm
• GS-042: 900 mm x 500 mm
• GS-043: 1000 mm x 700 mm

HOT PLATE WELDING DEVICE

• use of hot-plate with quick change sized and shaped according to the article and component to weld
• maximum temperature of the hot-plate: 400°
• differential adjustment of the temperature of the various heating zones of the hot-plate
• very short switch time for joining after the end of the melting
• automatic adaptation of the melting parameter of the article and of the joining parameter of the element, with elimination of the articles that do not comply with the coupling parameters and tolerances that have been set
• possibility to change coupling parameters and tolerance on the operator panel
• electric management of the melting and joining force of the components with the possibility to adjust the parameters on the operator panel

LOCALIZED INFRARED WELDING DEVICE

• differential adjustment of the temperature on the article side and on the element side
• very short switch time for joining after the end of the melting
• automatic adaptation of the melting parameter of the article and of the joining parameter of the element, with elimination of the articles that do not comply with the coupling parameters and tolerances that have been set
• possibility to change coupling parameters and tolerance on the operator panel
• electric management of the melting and joining force of the components with the possibility to adjust the parameters on the operator panel